1-1-6.SAF-T-BAR C型電軌(C SERIES CONDUCTOR)
1-1-6.SAF-T-BAR C型電軌(C SERIES CONDUCTOR)
1.C&W電軌系統(SAF-T-BAR)新目錄
1-1.SAF-T-BAR C型電軌(C SERIES CONDUCTOR) 下載down load
1-2.SAF-T-BAR H型電軌(H SERIES CONDUCTOR) 下載down load
1-3.SAF-T-BAR T型電軌(T SERIES CONDUCTOR) 下載down load
1-4.INSUL-8 8字型電軌(INSUL-8 CONDUCTOR) 下載down load
1-5.INSUL-8側向8型電軌(INSUL-8 SIDE CONTACT CONDUCTOR BAR) 下載down load
1-6.CLUSTER電軌CLUSTER BAR 下載down load
Series C Conductor Bars are roll-formed of galvanized steel or copper/steel laminate (250A) or copper (300A and 350A). The “U” shaped contact surface ensures positive tracking of the collector shoe and ensures good contact throughout the travel of the system. The standard material is supplied in 10 ft lengths with all necessary joining hardware. Installation is simple and requires only a jointing tool to connect the rails.
Ampacity range:
Based on continuous service with a 86OF (30OC) rise. Higher ratings can be obtained by increasing temperature rise and using high heat covers - Contact the Factory.
CA90 | 90 |
CA110 | 110 |
CA250 | 250 |
CA300 | 300 |
CA350 | 350 |
Bar Material:
CA90 1010 galvanized steel CA110 1010 galvanized steel CA250 Steel/copper
CA300 Copper
CA350 Electrolytic copper
Bar Features:
- Skin-tight insulation runs cooler, will not deform under clamping pressure
- Metal Guideways assure positive tracking of collector shoe
- Flat contact surface for long conductor wear and greatest possible sliding contact area
Collector Features:
- Contact shoe made with sintered copper and graphite, self-lubricating, draws current to collectors. Flat contact surface.
- Pantograph spring suspension of collector provides even pressure to shoe throughout stroke, yielding
maximum electrical and mechanical performance.
In wet and icy atmospheres, the system can be shielded with a protective hood for additional protection. In dirty and dusty atmospheres, mount the conductor in down-turned position (bottom entry).Atmospheric specifications
Insulating cover options
Standard is orange rigid PVC extrusion, 160OF (71OC) heat distortion point at 260 psi, self-extinguishing. Medium heat cover of red Lexan extrusion can be specified when necessary, 260OF (127OC) heat distortion point at 260 psi, self extinguishing. High heat fiberglass cover is available, 375OF (191OC) heat distortion.
Long run options
Push-in-place locking tabs are available if required for use on long runs with expansion gaps on copper and steel/copper conductor sections.