1-3-8.SAF-T-BAR T型電軌(T SERIES CONDUCTOR)

商品名稱:

1-3-8.SAF-T-BAR T型電軌(T SERIES CONDUCTOR)

詳細介紹:

1.C&W電軌系統(SAF-T-BAR)新目錄                                                                        
       1-1.SAF-T-BAR C型電軌(C SERIES CONDUCTOR)                                               下載down load1-1.SAF-T-BAR C型電軌(C SERIES CONDUCTOR) 
       1-2.SAF-T-BAR H型電軌(H SERIES CONDUCTOR)                                               下載down load1-2.SAF-T-BAR H型電軌(H SERIES CONDUCTOR)

       1-3.SAF-T-BAR T型電軌(T SERIES CONDUCTOR)                                                下載down load1-3.SAF-T-BAR T型電軌(T SERIES CONDUCTOR)

       1-4.INSUL-8 8字型電軌(INSUL-8 CONDUCTOR)                                                  下載down load1-4.INSUL-8 8字型電軌(INSUL-8 CONDUCTOR)

       1-5.INSUL-8側向8型電軌(INSUL-8 SIDE CONTACT CONDUCTOR BAR)              下載down load1-5.INSUL-8側向8型電軌(INSUL-8 SIDE CONTACT CONDUCTOR BAR)

       1-6.CLUSTER電軌CLUSTER BAR                                                                           下載down load 1-6.CLUSTER電軌CLUSTER BAR

Connects and aligns standard 10' conductor lengths. Consists of a 4" joint cover that slides over the exposed joint area to complete the insulation. The joint cover locks in place by means of indents and is formed of the same material as the insulating conductor cover. Splice joints are pre-installed on one of complete conductor

TJ65

The TF100 is a terminal lug with insulating cover that clamps onto a 3/4"  (19.1 mm) length of bare conductor to feed power to the bar. It will accept wires up to # 6 flex. Rated at 100 amperes. The conductor may also be fed by securing a standard terminal lug to

the 1/4"  hole in the end of the conductor and taping over it for insulation.

TF100

End Cap TN100C is a sleeve required to complete the insulation of the conductor. It extends 1/2"  (13 mm) over the end of the bar. As an alternative, the conductor may be cut back so that the regular insulating cover extends 1/2"  beyond the end of the conductor. End Cap may also be used as a transfer end cap having a ± 1/8" (± 3.2 mm) tolerance with a 1" (25 mm) gap setting on interlocks.

TN100C

A rigid plastic sleeve, providing 1/2"  (13 mm) over-surface gap electrically, for electrical segmentation of conductor bars. A self-supporting sleeve.

TA65IS

Nylon coated stamped steel hanger clamps. Can be furnished in multiples on 1" (25 mm)

centers. Can be mounted using cross bolt or back bolt.  Bolts are 1/4"  and require a

Phase

Part No.

1

TH101

2

TH201

3

TH301

4

TH402

5

TH502


5/16"  mounting hole. Hangers are required every 5' (1.52 m) of conductor. Joints should be located not more than 3" (76.2 mm) from hangers to avoid flexing.  

Note:  A spool mount insulator hanger option is available as an alternative - Contact Factory