1.C&W電軌系統(SAF-T-BAR)新目錄                                                                        
       1-1.SAF-T-BAR C型電軌(C SERIES CONDUCTOR)                                               下載down load 
       1-2.SAF-T-BAR H型電軌(H SERIES CONDUCTOR)                                               下載down load

       1-3.SAF-T-BAR T型電軌(T SERIES CONDUCTOR)                                                下載down load

       1-4.INSUL-8 8字型電軌(INSUL-8 CONDUCTOR)                                                  下載down load

       1-5.INSUL-8側向8型電軌(INSUL-8 SIDE CONTACT CONDUCTOR BAR)              下載down load

       1-6.CLUSTER電軌CLUSTER BAR                                                                           下載down load

Cross-bolt hanger clamps are factory set to snap in place, but must be field adjusted for correct sliding tension after installing the conductor (unless used as an anchor).

 

Sliding hangers (for conductor expansion): Tighten cross bolts, then back off 1/4 turn. Anchor hangers: Tighten cross-bolts to 6 ft lb.

Description Application Part No. Single Hanger, Plated Steel Indoors, clean, dry 100H   Steel Single Hanger, Stainless Steel   Indoors, corrosive environments   100HSS   Single Hanger, Plastic Coated Steel   Indoors, dirty, dry   100HN Single Hanger, with Insulator Spool, Plated Steel   Indoors/outdoors, wet, dirty   100K   Single Hanger, with Insulator Spool, Stainless Steel   Indoors/outdoors, wet, dirty, corrosive environments   100KSS Single Hanger, with Insulator Spool, Plastic Coated Steel Indoors, outdoors, wet, dirty, corrosive   100KN   Three-Pole Hanger, 1.5" Centers Indoors, clean, dry. Requires staggered collector mounting   100H3-1   Three-Pole Hanger, 2.0" Centers   Indoors, clean, dry. Does not require staggered collector mounting   100H3-2

Lexan snap-in  hangers for use only on Series C PVC cover rated to 160°F, with holding rib.  For high temperature applications, use Cross Bolt Hanger Clamps. All push-on

snap hangers require a firm press to seat the conductor into the hanger. To remove the conductor, it is recommended that it be slid out to avoid damage to the hanger.

Can use instead of: Application notes: Part No. 100H, 100HN, 100K, or 100KN Same mounting dimensions as 100H hanger 100P 100H, 100HN, 100K, or 100KN Same as 100P, with "rain hat" for severe outdoor conditions 100PH 100H3-1 Multiple pole, 1.5" (38.1mm) centers: Indoors, wet, dirty. Requires staggered collector mounting 100P3-1 100H3-2 Multiple pole, 2.0" (50.8mm) centers: Indoors, wet, dirty. Does not require staggered collector mounting 100P3-2

                                                           Anchor Hanger - Incorporates fiberglass     100PA
                                                          filler for added strength, includes Fiber
                                                          Pin Anchor Device inserted into 1/4" field-
                                                             drilled hole.