2-4. 使用方法1 & 2,APPLICATION - STEP 1 & 2
2-4. 使用方法1 & 2,APPLICATION - STEP 1 & 2
2.G型彈簧收回捲線器 下載down load
2-2. 基本設計原理G TYPE BASIC DESIGN
2-3. G型詳細配件DETAIL COMPONENTS OF G TYPE
2-4. 使用方法1 & 2,APPLICATION - STEP 1 & 2
2-5. 使用方法3、APPLICATINOn - STEP 3
2-6. 使用方法4 & 5 ,APPLICATION - STEP 4 & 5 .
2-7. 容量選用表(水平垂直使用)CAPACITY CHARTS
2-8. 固定式拉伸用STETCH
2-9. G14、G16 G14、G16 之尺寸圖DIMENSIONS
2-10. G19之尺寸圖DIMENSIONS OF G19
2-11. 問卷表QUESTIONNAIRE
2-12. 按裝相片INSTALLATION PHOTOS
Any application where cable is simply hoisted vertically with only the weight ofthe cable involved. Special consideration must be given to any weight added to the end ofthe cable such as a push button station.
Retrieve
A horizontal retrieve application is when the reel is mounted on the moving equipment winding in and paying out cable into a tray or other support. A vertical retrieve application is much the same as a verticallift except in this case the reel is located below rather than above.
Horizontal Stretch
Stretching cable horizontally requires the greatest amount oftension of any application to maintain a minimum sag.(AII capacities are based on a maxim um sag of 10%)
HorizontalDrag
This is considered a non-standard application due to the high spring
tension and involved,and the resultant detrimental effect on
cable life.
Forthis application please consult our sales office for advice.
One-Way Payout
Wlen obstructions or environmental conditions prohibit the placement of the power source at the centre of machine trave,l one-way payout (end feed) must be used. If one way
payout is used,then:
Active Cable Length = TravelLength
Two-Way Payout
In many applications,the power source can be brought to the centre
ofthe machine travel for two-way payout (centre feed).This permits the
use ofa smaller,less expensive reel
and only one-halfthe length of cable. For example,a 15m reel
accom modates a travel of 30m. AII
reelsa陪 designed with the two-way payout feature as standard. Iftwo
Active Cable Length way payout is used,